Flame bus error

[vr4]

I try to run flame 7 on 1 cpu 300Mhz MXE 512M no Discreet Stone ,DIVO
use system disk for frame store .
Run flame OK ---> Create partition OK ---> Create project OK
---> When i click start It show VOLUMEMGT Initialisig for 10 Sec'
and exit to shell show message

abnormal termination , signal = 10
SIGBUS - bus error
Signal was generate internally
invalid address alignment at address 0xffbe0060


... Why ??? ...

[kusanagi]

i have the same problem with flint on o2 running on irix 6.5.20 i downgrade my system to 6.5.7x now it works. I dont know why :?:

[vr4]

8O


---- How can i downgrad to 6.5.7 (Now 6.5.19) ?

[foetz]

8O


---- How can i downgrad to 6.5.7 (Now 6.5.19) ?

hello,

just load the base release and the desired overlay. might have to solve a few conflicts.
and be sure to choose feature stream if asked.

[kusanagi]

i found some pdf's on discreets support area they describes how to install Irix and Flint/Flame from scratch step by step. Sure you cannot directly downgrade your system try to re format your disk and install Irix again.

cu...
kusanagi

[vr4]

Yep , I have too (Flame install guide ) now i try to remove some irix feature
if not work i will Reinstall irix.. :lol:

Thanks..