Flame and VTR support

[butchie70]

Hi.

To setup Flame w/ VTR support for clip i/o is there anything that needs to be done aside from modifying the init.cfg and uncommenting the VTR profile? For some reason, the VTR mode shows up in"local" even though the VTR is in remote mode. Could this be a cable issue? I'm using an RS-422 w/ a gender changer on Octane.

TIA.

[imported_neonmarg]

Hi.
Could this be a cable issue? I'm using an RS-422 w/ a gender changer on Octane.


I believe there is a non standard pin out for the 422 ports...
SGI VTR
TX- 3 RX- 8
TX+ 4 RX+ 3
RX- 2 TX- 2
RX+ 6 TX+ 7
GND 5 GND 4

Jeff