- This topic has 5 replies, 5 voices, and was last updated 12 years, 7 months ago by .
-
Posts
-
Tried the 3D Tracker in 2007 for the first time and not sure if there was a thread on this subject. In the previous version it would put all the tracking data in your project and you could just load it into your setup. Well… I dont see it there in 2007. Where exactly does the tracking info save to. I can see it when im on camera but other than that I cant seem to find it saved anywhere to apply it to the necessary image. Thanks
When the tracking is done you have to select some of the tracking point and click convert. You’ll get a new camera and all the tracking point that you selected will become axes. Everything will be in the schematic. You don’t need to load any setup or camera.
You da man Martincito, thank you sir.
I know its Monday, but why does the manual of Flame 2007 show the setup for 3D tracking for ver. 9.5 and not 2007? According to the manual there should be Coord, Relations, Frams, Analysis etc but yet the software actually shows Calibrate, Refine, Track Layer etc. Am I missing something. LOL And yes selecting the trackers and using covert does create action nodes, but yet when the image is attached to the nodes it doesnt react? As it use to.
to get your image to move / react to the new 3D track you’ve just made, you may need to goto the camera submenu and switch it to result cam 2. you maybe still looking at your image thru the old (not moving) camera instead of the new 3D tracked camera you’ve just created.
also, the instructions for the 9.5 flame tracker may still be in the manual because they’ve kept the old Manual 3D tracker in the software as well as the new 3D tracker. you will see all those other attributes come up if you switch to “manual” 3D tracker.
regards,
T
- You must be logged in to reply to this topic.