Dead drive error message

Home Page forums Autodesk/Discreet Flame and Smoke Dead drive error message

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #202938
    Anonymous
    Inactive

    Hiya,

    I have a dead drive in my array and am archiving everything off but I keep
    getting the error message saying “Warning. Bad Disk found. Continue?”

    Is there any way to turn this off as it is slowing me down while I archive.

    I’m on a Tezro.

    Thanks
    Jimmy

    #217996
    kakutarvn
    Participant

    Are you planning on fixing (replaceing the drive)? Or are you going to rebuild the StoneFS with one less drive?

    I have done many “heals” and never archived anything and all has been well.
    I don’t think you can turn off the warning untill you do a heal or reconfig the stones. But I never tried.

    There might be a setenv for it.

    Brian

    #217997
    David Stewart
    Participant

    @BKM 28341 wrote:

    Are you planning on fixing (replaceing the drive)? Or are you going to rebuild the StoneFS with one less drive?
    Brian

    I will be healing but i am waiting on some drives to be shipped here. In the meantime i am just getting everything off the system as a safety backup (also because i finally have a free day so i can do some housekeeping).

    It’s not really a big deal, i can just keep hitting confirm.

    Thanks anyways.

    #217998
    Anonymous
    Inactive

    Thanks for getting back with me on this error. I will check out the other post, but I think this is due to a bad hard drive. Thanks again.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.
Copy link
Powered by Social Snap