nuke and mocha pro workflow problem

[gtravis]

I am not sure the best workflow to make the parameters between Nuke and Mocha Pro match so that exported shape data will paste into place in the rotopaint node in Nuke

Parameters that need to match:
clip length / frame rate / interlaced node / pulldown mode / PAR

In Nuke, original footage is 1440x1080_50i, but it has a Reformat Node applied (1920×1080) and a Field Select node applied – “even”.

In Mocha Pro, same footage imported (1440x1080_50i HDV), but for the Pixel Aspect Ratio, do I go with HDV 1.333 OR do I make the PAR: HD to match the final plate in Nuke?

I have run tests, but so far, all the shape data comes in to the Left of where*it out to be.*

mocha pro frame offset is 1
Where do I set the frame offset in Nuke? – to make sure they match?

Nuke parameters:
clip length: 1-812 frames (in & out points @ 60 and 190)
frame rate: 24 fps
interlaced mode: have been choosing upper field/odd (will switch to even)
pulldown mode:* haven’t done anything with this
PAR: HD

Mocha Pro parameters:
clip length: 1-812 (same in & out points)
frame rate: 24 fps
(bit depth is set to 24)
interlaced mode: even
pulldown mode – have not set
PAR: HDV 1.333
(I have also chosen PAR: DVDHD Pro (which as I understand it, is relatively the same as HDV
I have also set up the PAR to HD, but still the same problem)

Any advice or feedback would be greatly appreciated.

Thanks!

[Author]

Posts