- This topic has 5 replies, 4 voices, and was last updated 11 years, 3 months ago by .
-
Posts
-
Is it just me or do both Import Image and WiretapCentral refuse to see an exr sequence as a sequence? The file browser in both places will only see the files as individual frames. Is there something obvious I’m missing?
I’m on Flame 2010 SP3.
is “flat view” on for whatever reason?
Flat View was not on. To confuse me even more, the same thing just happened on a tiff sequence. Bizarre.
(Since 2009sp2) Sometimes the file browser is prone to messing up with a directory’s contents. Exiting and re-entering the import image / directory usually fixes it. Is the sequence Padding corectly setup?
Filenames should have been fine. Exiting/re-entering Import Image didn’t fix a thing. It hasn’t happened since my last post, but if/when it does, I’ll be sure to make note of the exact scenario. Sometimes noting bugs with good descriptions just doesn’t happen as it should in the heat of a long, high pressure day 😮
@AdamBerk 28468 wrote:
Sometimes noting bugs with good descriptions just doesn’t happen as it should in the heat of a long, high pressure day 😮
Hahaha.
my calls to Autodesk:“This thing happened, and it did it a few times, but I was busy and it’s not doing it now. Still can you fix it? I know it’s going to do it again.”
- You must be logged in to reply to this topic.