- This topic has 4 replies, 5 voices, and was last updated 10 years, 12 months ago by .
-
Posts
-
I’m setting Keyframes for the transparency of layers in action, and they look correct when I scrub my sequence (i.e turning on and off) but when I render I’m getting a 1 frame overlap on the keys. I’ve checked that they’re all set to constant, and they go from 0% trans to 100%. This is on 2010 Ex. 1.. Has anyone else seen this type of behavior and know how to get around it?
Thanks,
Glenn
have you got motion blur enabled?
sometimes i get a similar problem with transparency keyframes when motion blur is on.
try that,
dan
that was the problem.. Thanks!
Glenn
You should be able to control this by playing with the phase in the motion blur controls.
Not at the machine now though….
I had this same issue… As soon as I turned motion blur on.
So I went into the transparency keyframes and changed the key frames to Constant then Linear. Instead of Linear then Constant and viola no more problem.
- You must be logged in to reply to this topic.